Reset toyota Camry Maintenance Light
By
Pusahma satu
—
Thursday, May 24, 2018
—
Reset Maintenance Light Toyota Camry
Reset Toyota Camry Maintenance Light
How to reset upkeep required light on 2004-2015 Toyota Camry:
2007-2015
-With car ignition switched to ON setting, make certain odometer is showing "Tripmeter A", after that transform the ignition button to OFF placement
-Press and also hold the JOURNEY reset or SETTING button
-While holding reset button, switch ignition to ON placement
** w/ ENGINE START/STOP switch, maintain your foot off brake pedal and also press ENGINE START/STOP button twice to obtain Key On/ Engine Off mode
-Continuously hold the reset button up until the odometer displays "000000" and then the original worth is shown
-Transform the car off and back on to verify reset was accepted
2010-2015
-On the navigating display, press SETUP
-Then press VEHICLE, then MAINTENANCE
-Touch the preferred product where you have to reset (i.e. Engine Oil, Oil Filter, Tire Turning, etc.).
-From here, fill in the asked for areas with the new "Next Service" period (i.e. date and range till following service is due).
-Press OK when total.
-Repeat actions 3-5 for other solutions that were done.
2004-2006
-With lorry ignition switched to ON placement, make sure odometer reading is revealed, then transform the ignition switch to OFF placement.
-While holding reset switch, switch ignition to ON placement.
** w/ ENGINE START/STOP button, maintain your foot off brake pedal as well as press ENGINE START/STOP switch two times to get Key On/ Engine Off setting.
-Continue to hold the reset switch up until the odometer displays "000000" and/or the MAINT REQD light goes off.
-Turn the vehicle off as well as back on to verify reset was approved.
2004-2009
-On the navigating screen, press INFORMATION or ARRANGEMENT.
-Then touch UPKEEP.
-Touch the wanted product where you should reset (i.e. Engine Oil, Oil Filter, Tire Turning, and so on).
-From here, fill in the asked for areas with the brand-new "Next Solution" interval (i.e. date following service due and/or distance till following service schedules).
-Press OK when total.
-Repeat actions 3-5 for other solutions that were performed.
We hope you find these reset procedures practical.