How to Reset Maintenance Light On toyota Camry

This time around I will offer a tutorial regarding "How To Reset Maintenance Light On Toyota Camry" for it please review the write-up listed below.

How To Reset Maintenance Light On Toyota Camry

Ways to reset upkeep needed light on 2004-2015 Toyota Camry:

2007-2015

-With vehicle ignition changed to ON position, see to it odometer is showing "Tripmeter A", after that transform the ignition switch to OFF position
-Press and hold the TRIP reset or SETTING switch
-While holding reset button, button ignition to ON placement

** w/ ENGINE START/STOP switch, keep your foot off brake pedal and push ENGINE START/STOP switch two times to get Key On/ Engine Off setting

-Remain to hold the reset button until the odometer shows "000000" and afterwards the initial worth is presented

-Turn the vehicle off and back on confirm reset was approved

2010-2015

-On the navigating display, press SETUP
-After that press CAR, after that UPKEEP
-Touch the desired item in which you should reset (i.e. Engine Oil, Oil Filter, Tire Turning, and so on).
-From here, fill in the asked for areas with the brand-new "Next Service" period (i.e. day and range till following solution schedules).
-Press OK when full.
-Repeat actions 3-5 for any other solutions that were done.

2004-2006

-With automobile ignition changed to ON placement, make certain odometer reading is shown, after that transform the ignition button to OFF placement.
-While holding reset switch, switch ignition to ON position.

** w/ ENGINE START/STOP switch, maintain your foot off brake pedal and push ENGINE START/STOP button two times to get Key On/ Engine Off mode.

-Continuously hold the reset switch up until the odometer presents "000000" and/or the MAINT REQD light goes off.
-Turn the lorry off and back on to verify reset was approved.

2004-2009

-On the navigating display, press DETAILS or CONFIGURATION.
-Then touch MAINTENANCE.
-Touch the wanted item in which you should reset (i.e. Engine Oil, Oil Filter, Tire Rotation, etc.).
-From here, fill in the requested fields with the brand-new "Next Service" interval (i.e. date next solution due and/or distance till next service is due).
-Press OK when total.
-Repeat steps 3-5 for any other services that were done.

We hope you find these reset procedures valuable.

Tweet